- (619) 342-8320
- appliancerepairmarshall@gmail.com
- Mon.– Sun.: 8:00 AM -10:00 PM
$59.99 service call
Signs. Likely Causes. Solution.
Signs: No response when turning knobs or pressing touch controls; no heat or lights.
Likely Causes: Tripped circuit breaker, faulty power cord, defective control board, or blown internal fuse.
Solution: Check the breaker and power supply first. Inspect internal fuses and test the control board for continuity or replace if needed.
Signs: One or more elements stay cold even though turned on.
Likely Causes: Failed heating element, bad infinite switch, or wiring issue.
Solution: Test the heating element for continuity. If functional, test the infinite switch and replace faulty components.
Signs: "Hot surface" or burner light won’t turn off.
Likely Causes: Faulty surface element switch or stuck relay on the control board.
Solution: Test the surface switches; replace the defective switch or control board if needed.
Signs: Burners heat too slowly or don’t reach high temperature.
Likely Causes: Worn-out heating elements, failing infinite switch, or voltage drop.
Solution: Test voltage to the cooktop. Replace any underperforming elements or switches.
Signs: Visible cracks, often from impact or sudden temperature change.
Likely Causes: Dropped object, thermal shock, or improper installation.
Solution: The glass top must be replaced — do not use the cooktop with cracks due to safety risks.
 
															 
															Signs: Heating element continues to glow even after turning off.
Likely Causes: Stuck infinite switch or shorted control board relay.
Solution: Disconnect power immediately. Test and replace the infinite switch or control board.
Signs: Visible sparks, smoke, or burning smell during use.
Likely Causes: Damaged wiring, shorted element, or liquid spill reaching electrical components.
Solution: Turn off power. Inspect and replace damaged parts. Clean up any spills under the glass top.
Signs: Unresponsive buttons, flashing errors, or frozen display.
Likely Causes: Moisture on panel, control board failure, or sensor malfunction.
Solution: Dry the surface thoroughly. If unresponsive after reset, replace the touch control panel or board.
Signs: Burner cuts off before desired temperature is reached.
Likely Causes: Thermal limiter engaging too early, faulty sensor, or ventilation issue.
Solution: Test the limiter and temperature sensors. Ensure airflow isn’t obstructed.
Signs: Breaker trips every time the cooktop is used.
Likely Causes: Internal short circuit, damaged wiring, or water ingress.
Solution: Check wiring for damage or corrosion. Dry any moisture and replace shorted components.
Need reliable Electric Cooktop Repair? Marshall Appliance is your local expert in San Diego County. We service homes and small businesses with 5 years of experience, honest diagnostics, and manufacturer‑approved parts. Call (619) 342-8320 or email appliancerepairmarshall@gmail.com. We’re available 7 days a week with same‑day or next‑day appointments when available.
| Issue | Possible Cause | Typical Repair Time | Estimated Cost Range | 
|---|---|---|---|
| Won’t turn on | Tripped breaker, failed control board, door switch | 1–2 hours | $140–$260 | 
| Not heating / cooling | Burnt element, faulty compressor/fan, thermostat | 1.5–3 hours | $180–$420 | 
| Unusual noise | Worn bearings, fan obstructions, loose hardware | 1–2 hours | $150–$290 | 
| Leaking water | Clogged drain, worn gasket, inlet valve | 1–2.5 hours | $160–$320 | 
| Error codes | Sensor failure, software glitch, wiring | 1–2 hours | $140–$270 | 
| Electrical smell | Shorted wiring, overheating components | 1–2 hours | $170–$310 | 
Brands we service: Amana, Bosch, Dacor, DCS, Electrolux, Frigidaire, GE, Jenn-Air, Kenmore, KitchenAid, LG, Liebherr, Magic Chef, Maytag, Miele, Samsung, Sharp, Speed Queen, Sub-Zero, Thermador, Thor, U-Line, Viking, Whirlpool, Wolf.
Ready to book? Call (619) 342-8320 or email appliancerepairmarshall@gmail.com. We’re available 7 days/week across San Diego County.
🌟 At Marshall Appliance, we go beyond simple fixes. Our technicians share maintenance tips, energy‑saving advice, and guidance on extending the life of your appliance. Serving all of San Diego County, we proudly help households and businesses reduce downtime and enjoy reliable performance every day. Our repeat customers in Oceanside, Carlsbad, Vista, and across the county know they can trust us for honest, long‑lasting repairs.
 
															 
													 
													 
													Proudly serving the San Diego area with reliable appliance repair and maintenance services for both residential and commercial clients.
5142 Catocin Drive San Diego, CA 92115 United States
Mon. – Sun.: 8:00 AM-10:00 PM
© 2025. All rights reserved.
Book Your Appliance Repair in 3 Easy Steps